arduino:wio-setup-en
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| arduino:wio-setup-en [2025/12/13 13:01] – [Interface] babbel | arduino:wio-setup-en [2025/12/30 08:03] (current) – [Extra] rjversluis | ||
|---|---|---|---|
| Line 220: | Line 220: | ||
| LDR between 3V3 and GP28 needs 10 kOhm pulldown. (PicoW)\\ | LDR between 3V3 and GP28 needs 10 kOhm pulldown. (PicoW)\\ | ||
| This will report the brightness to Rocrail. ([[: | This will report the brightness to Rocrail. ([[: | ||
| + | |||
| + | ===Dual stepper=== | ||
| + | Enables a second stepper motor on I/O2. (Pico)\\ | ||
| + | A restart of WIO is needed to make this option active.\\ | ||
| Line 232: | Line 236: | ||
| | DCC | | | | DCC | | | ||
| | Mobile | | | | Mobile | | | ||
| + | | LNet | LocoNet support on UART0 and GP28. (Pico) | | ||
| \\ | \\ | ||
arduino/wio-setup-en.1765627261.txt.gz · Last modified: 2025/12/13 13:01 by babbel