Differences

This shows you the differences between two versions of the page.

--- cc-schnitte-en [2019/06/03 08:41] – created - external edit 127.0.0.1
+++ cc-schnitte-en [2025/12/19 12:02] (current) – rjversluis
@@ Line 7: / Line 7: @@
 =====CC-Schnitte V2=====
 This version uses the Märklin CS2 CAN protocol.\\
 [[http://www.can-digital-bahn.com/modul.php?system=sys5|{{http://www.can-digital-bahn.com/pages/module/CC_Schnitte/images/CC_Schnitte_2_1_klein.jpg?200}}]]\\
-====Setup====
+=====Setup=====
+{{:mbus:mbus-ccschnitte-en.png?480}}\\
 Set it up as a **[[:mbus:cs3-en|Märklin CS2/CS3]]** CS with type serial.\\
 Read also: __**[[:mbus:mbus-en|MBUS & TrackBox]]**__\\
  \\
-===Device===
+====Device====
 The serial device like COM3 under Windows or /dev/ttyUSB0 under Linux.\\
-===Type===
+====CTS====
-Serial.\\
+Hardware flow control with CTS.\\
-===Baudrate===
+====Type====
+CC-Schnitte.\\
+====Baudrate====
 .\\
-===CTS===
+====Special line settings====
-Hardware flow control with CTS.\\
+===DTR===
+Determine the serial DTR level on startup. None is default.\\
+Only used to adjust driver defaults.\\
-===Version===
+===RTS===
+Determine the serial RTS level on startup. None is default.\\
+Only used to adjust driver defaults.\\
+====Version====
 The version should be set to 2 to disable S88 polling continually.\\
-====Command Pause====
-This is for special CS2 compatible Command Stations which can not handle high data traffic.\\
-This sleep value will also be used for waiting on the next byte. (In some cases needed under Mac OSX: 17...20ms)\\
-Use **17 ms**.