Differences

This shows you the differences between two versions of the page.

--- cc-schnitte-en [2025/12/19 08:37] – rjversluis
+++ cc-schnitte-en [2025/12/19 12:02] (current) – rjversluis
@@ Line 7: / Line 7: @@
 =====CC-Schnitte V2=====
 This version uses the Märklin CS2 CAN protocol.\\
 [[http://www.can-digital-bahn.com/modul.php?system=sys5|{{http://www.can-digital-bahn.com/pages/module/CC_Schnitte/images/CC_Schnitte_2_1_klein.jpg?200}}]]\\
-====Setup====
+=====Setup=====
 {{:mbus:mbus-ccschnitte-en.png?480}}\\
 Set it up as a **[[:mbus:cs3-en|Märklin CS2/CS3]]** CS with type serial.\\
@@ Line 16: / Line 15: @@
  \\
-===Device===
+====Device====
 The serial device like COM3 under Windows or /dev/ttyUSB0 under Linux.\\
-===CTS===
+====CTS====
 Hardware flow control with CTS.\\
-===Type===
+====Type====
 CC-Schnitte.\\
-===Baudrate===
+====Baudrate====
 .\\
-====DTR====
+====Special line settings====
+===DTR===
 Determine the serial DTR level on startup. None is default.\\
 Only used to adjust driver defaults.\\
-====RTS====
+===RTS===
 Determine the serial RTS level on startup. None is default.\\
 Only used to adjust driver defaults.\\
-===Version===
+====Version====
 The version should be set to 2 to disable S88 polling continually.\\
-====Command Pause====
-This is for special CS2 compatible Command Stations which can not handle high data traffic.\\
-This sleep value will also be used for waiting on the next byte. (In some cases needed under Mac OSX: 17...20ms)\\
-Use **17 ms**.