ctc:ctc-led-en
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| ctc:ctc-led-en [2025/12/13 16:03] – [LED] babbel | ctc:ctc-led-en [2025/12/13 16:13] (current) – [LED] babbel | ||
|---|---|---|---|
| Line 78: | Line 78: | ||
| ===Rotate=== | ===Rotate=== | ||
| - | If the WS2811 board is operated with power supplied from the right, the LED assignment is mirrored here. | + | If the WS2811 board is operated with power supplied from the right, |
| + | |||
| + | |||
| + | \\ | ||
| ===Test== | ===Test== | ||
| Here, the assignment, position, and function of the LEDs on the circuit board can be tested. | Here, the assignment, position, and function of the LEDs on the circuit board can be tested. | ||
| - | |||
| \\ | \\ | ||
| Line 89: | Line 91: | ||
| The color mapping depends on the object type.\\ | The color mapping depends on the object type.\\ | ||
| Common are block and route states.\\ | Common are block and route states.\\ | ||
| + | The checkbox can be used to activate blinking.\\ | ||
| ===Brightness=== | ===Brightness=== | ||
| The brightness of the WS2812 LEDs.\\ | The brightness of the WS2812 LEDs.\\ | ||
| + | |||
| + | ===Preset Color=== | ||
| + | If this is enabled, the color and brightness settings from the preferences will be used.\\ | ||
| + | |||
| + | ===Delay=== | ||
| + | Controls the blinking frequency.\\ | ||
| ===Copy/ | ===Copy/ | ||
| Line 101: | Line 110: | ||
| \\ | \\ | ||
| - | ====Swap==== | ||
| - | Rotate the LEDs by 180°.\\ | ||
| - | |||
| - | \\ | ||
| =====Preset===== | =====Preset===== | ||
| {{: | {{: | ||
ctc/ctc-led-en.1765638205.txt.gz · Last modified: 2025/12/13 16:03 by babbel