Differences

This shows you the differences between two versions of the page.

--- roco:roco-z21-en [2025/12/21 11:21] – [Setup] rjversluis
+++ roco:roco-z21-en [2025/12/21 11:32] (current) – rjversluis
@@ Line 38: / Line 38: @@
-===== Setup =====
+=====Setup dialog=====
 {{:roco:z21-setup-en.png?500}}\\
+===== Connection =====
+====Interface ID====
+Command Station reference.\\
+====UniqueID====
+Default 21, if left zero, to be used as [[:powerman-en#uid|Booster UID]].\\
 ====Hostname/IP-Adresse====
@@ Line 48: / Line 55: @@
+=====Options=====
 ====Locomotives====
 :!: //Only use this option in case locomotives are controlled by an external throttle which connects directly to the Z21/z21.//\\
@@ Line 62: / Line 69: @@
 ====Booster events====
-This option must be activated, if Booster events should be received from the the z21 controller.
+This option must be activated, if Booster events should be received from the the z21 controller.\\
- \\
 ====LocoNet detectors====
 This option should only be activated if RailCom detectors are connected to the LocoNet bus of the z21 controller.\\
 It activates OPC_MULTI_SENSE events. For more information see capital **9.5** //LAN_LOCONET_DETECTOR// in the Z21 Protocol Specs.\\
 **Note:** //Leave this option disabled in case no RailCom detectors are connected.//\\
- \\
 ====multiMAUS====
 Check if the event is originated by the multiMAUS to signal Rocrail that it is a field event.\\
-====Program FB====
+====Watchdog====
+Check if the Z21 is online by sending every second a request.\\
+If after the timeout in seconds no response came in, the Z21 is regarded as offline.\\
+The Z21 will be re-initialized if it comes online again.\\
+ \\
+ \\
+ \\
+=====Program FB=====
 {{ :roco:z21-10787.jpg?400}}
 Program a Roco 10787 sensor module.\\
@@ Line 80: / Line 96: @@
   - :!: Program address zero after the sensor module has acknowledged.
-==== Switch time ====
+===== Switch time =====
 Default output activation time for switches.\\
 This value is only used in case the __**[[:switch-int-en#switch_time|Switch time]]**__ for a individual turnout is zero.\\