Differences

This shows you the differences between two versions of the page.

--- sprog-en [2026/01/07 15:27] – [Related pages] rjversluis
+++ sprog-en [2026/01/07 15:56] (current) – rjversluis
@@ Line 39: / Line 39: @@
 ===== Setup =====
-Only the IID and the serial port has to be set, the rest is fixed in the firmware of the SPROG line.\\
+{{:sprog:sprog-setup-en.png?400}}\\
-{{:sprog:sprog-setup-en.png}}\\
+====Interface ID====
+Unique name of this controller.\\
-====Nano====
+====Device====
+The serial device connected with the SPROG.\\
 SPROG 3 and S_Nano have device name "/dev/ttyACM0" under Linux.\\
+====Purge====
+The purge time in seconds before a locomotive will be purged if no commands has been send.\\
+Setting this value to zero will disable purging.\\
-====Pi-SPROG====
+=====Pi-SPROG=====
 The Pi-SPROG can only be used if Rocrail runs on the Raspberry Pi on which the Pi-SPROG is connected.\\
 Pi-SPROG has the device name "/dev/ttyAMA0" under Linux/Raspbian.\\
@@ Line 56: / Line 62: @@
 {{:sprog:pisprog-en.png?800}}\\
-===Pi-SPROG 3v2===
+====Pi-SPROG 3v2====
 The serial BPS must be set to 460800.\\