sprog-en
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| sprog-en [2026/01/07 15:51] – [Setup] rjversluis | sprog-en [2026/01/07 15:56] (current) – rjversluis | ||
|---|---|---|---|
| Line 39: | Line 39: | ||
| ===== Setup ===== | ===== Setup ===== | ||
| - | {{: | + | {{: |
| ====Interface ID==== | ====Interface ID==== | ||
| Unique name of this controller.\\ | Unique name of this controller.\\ | ||
| ====Device==== | ====Device==== | ||
| The serial device connected with the SPROG.\\ | The serial device connected with the SPROG.\\ | ||
| + | SPROG 3 and S_Nano have device name "/ | ||
| ====Purge==== | ====Purge==== | ||
| The purge time in seconds before a locomotive will be purged if no commands has been send.\\ | The purge time in seconds before a locomotive will be purged if no commands has been send.\\ | ||
| Line 49: | Line 50: | ||
| - | ====Nano==== | ||
| - | SPROG 3 and S_Nano have device name "/ | ||
| - | ====Pi-SPROG==== | + | =====Pi-SPROG===== |
| The Pi-SPROG can only be used if Rocrail runs on the Raspberry Pi on which the Pi-SPROG is connected.\\ | The Pi-SPROG can only be used if Rocrail runs on the Raspberry Pi on which the Pi-SPROG is connected.\\ | ||
| Pi-SPROG has the device name "/ | Pi-SPROG has the device name "/ | ||
| Line 63: | Line 62: | ||
| {{: | {{: | ||
| - | ===Pi-SPROG 3v2=== | + | ====Pi-SPROG 3v2==== |
| The serial BPS must be set to 460800.\\ | The serial BPS must be set to 460800.\\ | ||
sprog-en.1767797511.txt.gz · Last modified: 2026/01/07 15:51 by rjversluis