CAN-digital-Bahn

Content → Command Stations → CAN-digital-Bahn

This version uses the Märklin CS2 CAN protocol.

Set it up as a Märklin CS2/CS3 CS with type serial.
Read also: MBUS & TrackBox

The serial device like COM3 under Windows or /dev/ttyUSB0 under Linux.

Hardware flow control with CTS.

CC-Schnitte.

500000.

Determine the serial DTR level on startup. None is default.
Only used to adjust driver defaults.

Determine the serial RTS level on startup. None is default.
Only used to adjust driver defaults.

The version should be set to 2 to disable S88 polling continually.

See for special support: Sensor events

• http://www.can-digital-bahn.com

Setup as Lenz XpressNet CS.

• LI101F
• 19200, CTS
• V2