This is an old revision of the document!
Table of Contents
LED de couleur du TCO
Index
Haut/Bas
Déplace le module sélectionné dans la liste.
Le tri doit être la colonne du numéro du module, qui est la valeur par défaut.
Signe égal
Renumérote les modules comme listés et calcul le décalage de la LED pour chaque module de la chaîne.
Effacer
Efface le module TCO sélectionné.
Module
Identifiant Interface
L'identifiant Interface du contrôleur TCO.
Module number
The module number in the CTC chain.
This number is used to calculate the LED offset.
Mapping ID
The Mapping ID is only used for CTC simulation in this plan file.
Leave empty for normal setups.
Text PS
Text point size in case of display simulation.
Button
Node ID
The Node ID on wich this button is connected as input.
T1
The input address.
LED
The optional feedback LED which will light in case the button is pressed.
LED
Node ID
The Node ID on which the WS29812 Pixel chain is connected.
Offset
The WS2812 chain offset.
LED1-LED6
Selecting the active LEDs is done by three state checkboxes:
| Checkbox state | Meaning | Remark |
|---|---|---|
 | Not used | LED is electrically bridged. |
 | Skipped | Is addressable but not used by this CTC setup.1) |
 | Used |
Note: At the time of writing the 'Skipped' checkbox state is not possible using Linux Mint DE. (LMDE) See Forum(DE)
Function
If the function LED is other then default it can be specified by setting this to > 0.
A function LED is for example the LED which shows the signals aspect.
Preset
Set the LED checkboxes according the default for the object type.
Color
Mapping
The color mapping depends on the object type.
Common are block and route states.
Brightness
The brightness of the WS2812 LEDs.
Copy/Paste
For copying the color into another CTC module setup.
Preset
Set the default colors.
Swap
Rotate the LEDs by 180°.
Preset
Save
Save the preset colors in the Rocview properties.
CTC Simulation
- Initialise after startup with Control → Start of day → Init field