Differences

This shows you the differences between two versions of the page.

--- loconet-easy-en [2026/01/07 07:48] – rjversluis
+++ loconet-easy-en [2026/01/07 09:03] (current) – rjversluis
@@ Line 1: / Line 1: @@
-====== LocoIO I/O Setup ======
+====== LocoIO I/O ======
 [[:english#rocview|{{  :viewer.png}}]][[:english|{{  :rocrail-logo-35.png}}]]
 [[english|Content]] -> [[english#rocview|Rocview]] -> [[english#programming_dialogs|Programming]] -> **Stationary Decoders**\\
-   * **[[lnsv-en|LocoIO]]** (GCA50)
+  * [[lnsv-en|General]] | [[locoio-addr-en|Query]] | **[[loconet-easy-en|I/O]]** | [[loconet-io-en|Port]] | [[locoio-opc-en|OPC]] |  [[locoio-multi-en|MultiPort I/O]] | [[locoio-servo-en|Servo]]
-     * [[lnsv-en|General]] | [[locoio-addr-en|Adresses]] | **[[loconet-easy-en|Easy Setup]]** | [[loconet-io-en|I/O]] | [[locoio-opc-en|OPC]] |  [[locoio-multi-en|MultiPort I/O]] | [[locoio-servo-en|Servo]]
 // \\ // \\
-If only simple I/O is needed this tab will do the job in a few clicks.\\
+Setup the basic I/O configuration in a few clicks.\\
- \\
+The module address is used from [[lnsv-en|General]] tab.\\
-The "Easy Setup" uses the module address from Tab General.\\
 {{locoio-easy-en.png?800}}\\
-This setup example connects a [[mgv-overview-en|GCA93]] (current sensors) and a [[mgv-overview-en|GCA136]] (servo driver).
@@ Line 16: / Line 14: @@
 Port address in range from 1 to 2048.\\
 The used addressing scheme is [[addressing-en#port_accessory_decoder_address_pada|PADA]].\\
+For **[[:wio:wiopico-io16lnet-en|WIOpicoLNet]]** the port addresses are fixed and dependents on the **[[:lnsv-en#low|Low Address]]**. (Low address * 16 + port number)\\
  \\