Differences

This shows you the differences between two versions of the page.

--- loconet-easy-en [2026/01/07 08:46] – [Address] rjversluis
+++ loconet-easy-en [2026/01/07 09:03] (current) – rjversluis
@@ Line 1: / Line 1: @@
-====== LocoIO I/O Setup ======
+====== LocoIO I/O ======
 [[:english#rocview|{{  :viewer.png}}]][[:english|{{  :rocrail-logo-35.png}}]]
 [[english|Content]] -> [[english#rocview|Rocview]] -> [[english#programming_dialogs|Programming]] -> **Stationary Decoders**\\
-   * **[[lnsv-en|LocoIO]]** (GCA50)
+  * [[lnsv-en|General]] | [[locoio-addr-en|Query]] | **[[loconet-easy-en|I/O]]** | [[loconet-io-en|Port]] | [[locoio-opc-en|OPC]] |  [[locoio-multi-en|MultiPort I/O]] | [[locoio-servo-en|Servo]]
-     * [[lnsv-en|General]] | [[locoio-addr-en|Query]] | **[[loconet-easy-en|I/O]]** | [[loconet-io-en|Port]] | [[locoio-opc-en|OPC]] |  [[locoio-multi-en|MultiPort I/O]] | [[locoio-servo-en|Servo]]
 // \\ // \\
-If only simple I/O is needed this tab will do the job in a few clicks.\\
+Setup the basic I/O configuration in a few clicks.\\
- \\
+The module address is used from [[lnsv-en|General]] tab.\\
-This //'Easy Setup'// uses the module address from Tab General.\\
 {{locoio-easy-en.png?800}}\\