Differences

This shows you the differences between two versions of the page.

--- loconet-io-en [2019/01/21 07:46] – created - external edit 127.0.0.1
+++ loconet-io-en [2026/01/07 09:03] (current) – rjversluis
@@ Line 1: / Line 1: @@
-====== LocoIO I/O======
+====== LocoIO Port======
 [[:english#rocview|{{  :viewer.png}}]][[:english|{{  :rocrail-logo-35.png}}]]
 [[english|Content]] -> [[english#rocview|Rocview]] -> [[english#programming_dialogs|Programming]] -> **Stationary Decoders**\\
-   * **[[lnsv-en|LocoIO]]** (GCA50)
+  * [[lnsv-en|General]] | [[locoio-addr-en|Query]] | [[loconet-easy-en|I/O]] | **[[loconet-io-en|Port]]** | [[locoio-opc-en|OPC]] |  [[locoio-multi-en|MultiPort I/O]] | [[locoio-servo-en|Servo]]
-     * [[lnsv-en|General]] | [[locoio-addr-en|Adresses]] | [[loconet-easy-en|Easy Setup]] | **[[loconet-io-en|I/O]]** | [[locoio-opc-en|OPC]] |  [[locoio-multi-en|MultiPort I/O]] | [[locoio-servo-en|Servo]]
 // \\ // \\
-{{locoio-io-en.png}}\\
+{{locoio-io-en.png?800}}\\
-Use the **[[loconet-easy-en|Easy Setup]]** if you are not an expert or only need pre defined settings.\\
+Use the **[[loconet-easy-en|I/O]]** tab if you are not an expert or only need pre defined settings.\\
  \\
@@ Line 47: / Line 46: @@
  \\
-=====LocoIO SV's=====
-The opcode OPC_PEER_XFER is used to exchange data between computer and decoder.\\
-John Jabour designed LocoNet module PCB's which also are programable with SV's.\\
- \\
-{{:loconet:lio-sw:locoio.pdf}}